HOMCOM 823-044V70 Manual Del Usuario página 12

1）take out the outer connector assembly and the exhaust pipe assembly, and
remove the plastic bags;
2）insert the heat pipe assembly (the end of the exhaust joint) into the back panel
vent slot (push to the
left) and complete the assembly (as shown in figure 1).
1.2 Installation of window sealing plate components
1)
Half open the window，and mount the window sealing plate assembly to the
window (as shown in Fig.2 and Fig.3).Components can be placed in horizontal and
vertical direction.
3)
Pull various components of the window sealing plate assembly open, adjust their
opening distance to bring
both ends of the assembly into contact with the window frame, and fix various
components of the assembly.1.2 Install the window sealing plate assembly
Notes: 1: The flat end of the exhaust pipe joints must be snapped into place.
2: The pipe cannot be distorted nor has substantial turning (greater than 45 °).
Keep the ventilation of the exhaust pipe unblocked.
Figure 2
4)
Move the unit with installed heat pipe and fittings before the window, and the
distance between the body and walls or other objects shall be least 50 cm (as
shown in Fig.4).
Figure4
11
Figure 3