Publicidad
Idiomas disponibles
Idiomas disponibles
Fig. 3: Product variant AV05-B-design
Fig. 4: Product variant AES series 500
6 Assembly and installation
Before you start with the installation: Familiarize yourself with the basic specifica-
tions for assembly as early as possible in advance. See
g 6.3 Preparation.
6.1 Notes on safety
To eliminate risks during assembly, observe the notes on safety. See g 2. Safety.
6.2 Planning
In the following, you will read which basic requirements must be met so that you
can successfully and safely assemble the product.
Do not carry out the preparation and installation steps until you have successfully
completed the planning.
6.2.1 Basic requirements
The following specifications apply to the assembly of all products.
Installation-specific requirements
• Observe the set-up regulations in the country of use.
• Assembly only by qualified personnel. See
Ambient conditions
• Only use the product in non-aggressive industrial atmospheres.
DANGER! Do not use the product in explosive areas. Only then can explosion
protection be guaranteed.
• Let the product acclimatize for a few hours before installation. Otherwise wa-
ter may condense in the housing.
AVENTICS™ AES | R412018150-BAL-001-AC | English
g 6.2 Planning
and
g 2.5 Personnel
qualifications.
6.2.2 Installation conditions
General requirements
• Make sure that the product is installed in a manner that protects it from all
types of mechanical loads.
• Protect the product from direct sunlight and UV radiation.
Product-specific requirements
• Mounting orientation. See
g 15. Technical
6.2.3 Required accessories, materials and tools
Mounting material
Use the supplied mounting material. Important information for assembly:
• Dimensions. See
g 3. Scope of
• Tightening torques. See g 6.4 Installation.
Tools
• Only use suitable tools (accident prevention, material protection).
6.3 Preparation
6.3.1 Notes
• Do not carry out any work on the system during preparation (accident preven-
tion).
6.3.2 Unpacking and checking the product
1. Check the material number to see if the product matches your order.
2. Check the product for transport and storage damage.
Do not install a damaged product. Return damaged products together with
the delivery documents. See back cover.
3. Prepare required accessories, materials and tools.
6.3.3 Implementing safety measures
Procedure
All work has to be prepared as follows:
1. Close off dangerous areas (accident prevention).
2. Make sure the system or system part is not under pressure or voltage (acci-
dent prevention, material protection).
3. Protect the system against being restarted (accident prevention).
4. Allow the product and adjacent system parts to cool down (accident preven-
tion).
5. Wear PPE (accident prevention).
6.4 Installation
Assembly options
• Assembling the adapter module AES-B-design. See
B-design.
• Assembling the adapter module AV05-B-design. See
AV05-B-design.
• Assembling the adapter module AES series 500. See
series
500.
6.4.1 Installing the product
Notes
• Ensure that the seal between the housings is properly seated in the slot.
• Ensure that the plug connector pins are not bent and make contact with the
corresponding socket in the bus coupler or base plate.
• Make sure that the triple row socket strip is not offset from the pins on the
valve system.
• Ensure that connecting cables are not trapped.
data.
delivery.
g 6.4.2 Assembling AES-
g 6.4.3 Assembling
g 6.4.4 Assembling AES
18
Publicidad
