SOMFY Roll Up Basic 28 WFRTS Instrucciones página 11

Roll Up Basic 28 WF RTS Li-ion
2.3.6.Recording "Pairing" the control point
After recording the end limits:
▪ Briefly press the control point PROG
button.
◦ The motorised product briefly moves up
and down to confirm pairing.
→ The control point is recorded "paired" to the
motorised product and green LED blinks 5 times.
2.4.Tips and advice on installation
2.4.1.Questions about the product?
Observations
The motorised product
does not operate.
©
Copyright 2021 SOMFY ACTIVITES SA. All rights reserved.
Possible causes
The drive battery is low and
requires charge. Red LED
blinks 5 times when any
button of a paired control
point is pressed.
The control point battery is
low. LED doesn't light
when any button of a
paired control point is
pressed.
The control point is not
compatible or not
programmed. LED doesn't
light when any button of
control point is pressed.
An obstacle hinders the
movement of the
motorised product. The
Red LED lights fixed on.
0.5 s
PROG.
Solutions
Charge the battery.
Check the battery and
replace it as required.
Check the compatibility or
pair the control point as
required referring to
Adding/Deleting control
points [} 20].
Remove the obstacle.
EN
11