Bosch 1617 Instrucciones De Funcionamiento Y Seguridad página 14

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

BM 2610908996 5/03
ROCKER "ON/OFF" SWITCH
Your tool can be turned "ON" or "OFF" by the
rocker switch located on the motor housing.
One side of the switch is marked "I" for "ON",
and the other side of switch is marked "O" for
"OFF". Also the edge of switch displays red
when switch is in the "ON" position.
TO TURN THE TOOL "ON": Push the side of
the switch marked "I".
TO TURN THE TOOL "OFF": Push the side of
the switch marked "O".
Always hold the router off the work when
turning the switch on or off. Contact the work
with the router after the router has reached full
speed, and remove it from the work before
turning the switch off. Operating in this manner
will prolong switch and motor life and will
greatly increase the quality of your work (Fig. 1).
ROCKER POWER "ON-OFF" WITH TRIGGER
SWITCH AND "LOCK-ON"BUTTON
(Models 1618 & 1618EVS only)
The power is switched "ON" by the rocker
switch located on the top of the motor housing
as described above. Now your tool can be
turned "ON" or "OFF" by squeezing or
releasing the trigger. Your tool is also equipped
with "Lock-ON" button located just above the
trigger that allows continuous operation without
holding the trigger (Fig. 2).
TO LOCK SWITCH ON: Squeeze trigger,
depress button and release trigger.
TO UNLOCK THE SWITCH: Squeeze trigger
and release it without depressing the "Lock-
ON" button.
If the "Lock-ON" button is
WARNING
!
continuously
depressed, the trigger cannot be released.
On models 1617 & 1618 hold the tool with both
hands while starting the tool, since torque from
the motor can cause the tool to twist.
SOFT START FEATURE
(Models 1617EVS & 1618EVS only)
Electronic feedback control minimizes torque
twist customary in larger routers by limiting the
speed at which motor starts.
5/20/03
9:06 AM
Page 14
being
-14-
ELECTRONIC VARIABLE SPEED CONTROL
(Models 1617EVS & 1618EVS only)
The electronic speed control feature allows
motor speed to be matched to cutter size and
material hardness for improved finish, extended
bit life, and higher performance. Speed
changes are achieved by rotating Control Dial
RIGHT to increase speed, LEFT to decrease as
indicated on housing (Fig. 1). Speed may be
changed while tool is on. The reference
numbers on the dial facilitate re-setting control
to desired speed.
The speed chart indicates the relationship
between settings and application, exact
settings are determined by operator experience
and preference. The bit manufacturer may also
have a speed recommendation.
DIAL
SETTING
RPM
APPLICATION
1
8,000
Nonferrous metals,
}
2
13,500
larger diameter bits,
and cutters
3
16,500
Softwoods, plastics,
4
20,000
}
counter tops, smaller
5
21,500
diameter bits, and
6
25,000
cutters
CONSTANT RESPONSE™ CIRCUITRY
(Models 1617EVS & 1618EVS only)
The router's Constant Response™ Circuitry
monitors and adjusts power to maintain the
desired RPM for consistent performance and
control.

Publicidad

Tabla de contenido
loading

Tabla de contenido