Publicidad
Idiomas disponibles
Idiomas disponibles
GB
IE
4. Loosen the clamping screw (22) with
the Allen key (24).
5. Now, remove the clamping screw (22)
and the clamping flange (21).
6. Pull the pull lever for the protective
hood (23) all the way back and hold
the protective hood (9) in this position.
7. Carefully remove the saw blade (8)
from the device from below.
8. Install the saw blade (8) in the reverse
order.
WARNING! The arrow on the saw
blade must match the direction ar-
row (direction of travel, marked on
the protective hood).
Make sure that the saw blade is
suitable for the speed of the tool.
Connecting the dust
extraction
There are three options for connecting the
permitted dust and shavings extraction.
Depending on the diameter of the hose
for the dust and shavings extraction, select
one of the following options:
• Connecting the dust and shavings
extraction directly
1. Connect the dust and shavings
extraction directly to the shavings
ejector (17).
• Connecting the dust and shavings
extraction to the adapter (20)
1 Place the dust extraction adapter
(20) on the shavings ejector (17).
2. Connect the dust and shavings ex-
traction to the adapter (20).
• Connecting the dust and shavings
extraction to the adapter (20) and
reducer (20a)
30
1. Place the dust extraction adapter
(20) on the shavings ejector (17).
2 Place the reducer (20a) on the dust
extraction adapter (20).
3. Connect the dust and shavings ex-
traction to the adapter (20).
When working with materials that
produce dangerous dust, connect
the device to an appropriate, tested
dust class M suction device.
Mounting the parallel
stop
1. Loosen the butterfly screw for the pa-
rallel stop holder (12) and insert the
parallel stop (11) in the parallel stop
holder (10).
2. Set the desired cutting width using the
scale on the parallel stop and the reces-
ses on the bottom side of the baseplate
(see also Fig. D). The left recess on the
bottom of the baseplate is for cutting
angle setting 0°. The right recess on the
bottom of the baseplate is for cutting
angle setting 45°.
3. Retighten the butterfly screw for the par-
allel stop holder (12).
Overload warning
• If the device is in danger of being da-
maged, the overload warning indicator
19) lights up briefly. The device
(
turns off.
Publicidad
