Publicidad
Idiomas disponibles
Idiomas disponibles
A(mm)
B(mm)
760
50 mini
Before you install the hob, make sure that
•
the work surface is square and level, and no structural members interfere with space
requirements.
•
the work surface is made of a heat-resistant material.
•
if the hob is installed above an oven, the oven has a built-in cooling fan.
•
the installation will comply with all clearance requirements and applicable standards
and regulations.
•
a suitable isolating switch providing full disconnection from the mains power
supply is incorporated in the permanent wiring, mounted and positioned to comply
with the local wiring rules and regulations.
•
The isolating switch must be of an approved type and provide a 3mm air gap contact
separation in all poles (or in all active [phase] conductors if the local wiring rules
allow for this variation of the requirements).
•
the isolating switch will be easily accessible to the customer with the hob installed
•
you consult local building authorities and by-laws if in doubt regarding installation
you use heat-resistant and easy-to-clean finishes (such as ceramic tiles) for the wall
•
surfaces surrounding the hob.
When you have installed the hob, make sure that
•
The power supply cable is not accessible through cupboard doors or drawers.
•
There is adequate flow of air from outside the cabinetry to the base of the hob.
•
If the hob is installed above a drawer or cupboard space, a thermal protection barrier
is installed below the base of the hob.
•
The isolating switch is easily accessible by the customer.
Before locating the fixing brackets
The unit should be placed on a stable, smooth surface (use the packaging). Do not apply
force onto the controls protruding from the hob.
Locating the fixing brackets
•
The unit should be placed on a stable, smooth surface (use the packaging). Do not
apply force onto the controls protruding from the hob.
•
Fix the hob on the work surface by screw four brackets on the bottom of hob (see
picture) after installation.
•
Adjust the bracket position to suit for different work surface's thickness.
C(mm)
D
20 mini
Air intake
24
E
Air exit 5mm
Publicidad
