Electrical Connections - Erreka AR24C Manual Del Instalador

5

ELECTRICAL CONNECTIONS

A- AR24C with 24Vdc control panel with limit switch (VIVO-D203)
A2
A1
B- AR220C with 230Vac control panel without encoder (VIVO-M201)
A2
A1
C Capacitor
FC1 Limit switch 1
FC2 Limit switch 2
M Motor
1 Complete the connections as shown in the figure:
1 Grey cable: common limit switches (FC1 and FC2)
2 Brown cable: limit switch 1 (FC1)
3 Black cable: limit switch 2 (FC2)
4 Blue/black cable: motor (24Vdc)
5 Red cable: motor (24Vdc)
2 Use ST1 (open), ST2 (close) to check the correct
operation of the actuator (parameter C1 for A1, C2
for A2).

Check the instructions for the control panel in
order to install the other electrical components.
3 Adjust the travel using the ends of travel of the
actuator (see "Adjust the ends of travel" on
page 20).
P64Xb
1 Complete the connections as shown in the figure:
1 Yellow/green cable: earth
2 Brown cable: turn 1
3 Grey cable: common
4 Black cable: turn 2
2 Use PUL1 (close), PUL2 (open) to check the correct
operation of the actuator.

Check the instructions for the control panel in
order to install the other electrical components.
3 Adjust the travel using the ends of travel of the
actuator (see "Adjust the ends of travel" on
page 20).
P64Yb
INSTALLATION
ARC electro-mechanical actuator
21