Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
REPLACING OVEN BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows.
Access the pilot light through the opening
1)
provided at the bottom of the appliance.
Unscrew the cap (B).
2)
Remove the nozzle (C) and replace it with the
3)
one suitable for the type of gas in use (see
table at the end of the manual).
Fit the cap (B) back in place.
4)
To carry out this operation, proceed as follows.
Close the gas supply tap.
1)
Undo the screws (B) and remove the control
2)
panel (A).
Loosen the screw (C).
3)
Remove the bushing (D) and replace it with
4)
the one suitable for the type of gas in use (see
table at the end of the manual).
After completing the operation, fi t the control
5)
panel (A) back in place.
APPLIANCE DECOMMISSIONING, SCRAPPING AND DISPOSAL
NOTE: Read the following section of
the "user instruction manual" carefully be-
fore replacing any part:
– Hazards and safety provisions during decom-
missioning.
When decommissioning the appliance, a set
of procedures should be carried out to ensure
that the appliance and its components are not
a hindrance and are not easily accessible.
To prevent the appliance from posing risks to
people or the environment, disconnect and
disable all energy sources (electricity, etc.), and
drain any liquids (lubricants, oils, etc.).
18
REPLACING THE OVEN BURNER AIR BUSHING
A
B
Place the appliance in a suitable and not easily
accessible area, with barriers to prevent anyone
from accessing it.
When scrapping, sort all components by chem-
ical characteristics and dispose of them sepa-
rately in accordance with the relevant applica-
ble laws.
IMPORTANT: Never dump non-bio-
degradable materials, lubricating oils and
non-ferrous metal components (rubber,
PVC, etc.) in the environment. Dispose of
them in accordance with the applicable laws.
PART REPLACEMENT
C
B
C
D
3386390_inst_GB_rev.1
Publicidad
