Supplementary safety instructions for working with wire brushes
Special safety instructions for working with wire brushes
a) Be aware that the brush can lose wire bristles even during normal operation. Do
not overstress the wires by applying excessive pressure to the brush. The wire bristles
can easily penetrate light clothing and/or skin.
b) Allow the brush to run at working speed for at least one minute before applying it
to the workpiece. Ensure that no one is standing in front of or in line with the brush
during this time. Loose pieces of wire can fly off during the run-in period.
c) Aim the rotating steel brush away from yourself. When working with these brushes,
small particles and minute pieces of wire can fly off at great speed and pierce skin.
Use
■
Never use the appliance for other purposes and use it only with original parts/
accessories. Using attachments or accessory tools other than those recommended in
the operating instructions can lead to a risk of injury.
Charging the integrated battery
WARNING!
►
If the charging cable or connections are damaged, have them replaced by an author-
ised specialist or the customer service department.
►
Protect the charging cable from hot surfaces and sharp edges.
►
Ensure that the charging cable is not stretched tightly or kinked.
►
Use only the supplied charging cable to charge the device.
►
Do not charge the appliance from the USB port of a PC or notebook.
►
Charge the appliance's internal battery only in dry indoor spaces.
NOTE
►
A new battery or a battery which has not been used for a long time will need to be
charged before first use/reuse. It will reach its full capacity after 3–5 charge cycles.
Start charging
♦
Connect the USB Type-C connector on the USB charging cable
socket
on the appliance.
♦
Connect the USB Type-A plug of the USB charging cable
(5 V, ≤ 4 A).
♦
Connect the USB mains adapter to a power socket.
The battery is fully charged when the battery LED
PFBS 12 C7
to the charging
to a USB mains adapter
shows RED/ORANGE/GREEN.
GB │ IE
│
11
■