Publicidad
Idiomas disponibles
Idiomas disponibles
EN
Do not use dirty, used or contaminated oil. Damage can
occur to the bar or chain.
7.3
ASSEMBLE THE GUIDE BAR AND
THE CHAIN
1. Loosen the chain cover by turning the bar nut (8)
counterclockwise.
2. Remove the chain cover (14).
3. Put the chain drive links (17) into the bar groove (15).
4. Put the chain cutters (16) in the direction of the chain
operation.
5. Put the chain in position and make sure that the loop is
behind the guide bar.
6. Hold the chain and bar.
7. Put the chain loop around the sprocket (18).
8. Make sure the chain tension pin hole (19) on the guide
bar fits correctly with the bolt.
IMPORTANT
16
15
17
English
18
9. Install the chain cover.
10. Tighten the chain. Refer to Adjust the chain tension.
11. Tighten the bar nut when the chain is correctly tensioned.
If you start the chain saw with a new chain, have a test for
2-3 minutes. A new chain gets longer after the first use,
examine the tension and tighten the chain if necessary.
7.4
FIT THE POLE SAW
1. Mount the pole saw head on pole saw handle to achieve
the standard length.
2. Slide the collar upwards.
3. Turn the collar clockwise to tight it.
8
19
NOTE
Publicidad
