Emerson DORIAN ECO Manual Del Usuario página 21

7. Wall Control Installation
7.5
This Control is designed to operate only one Ceiling
Fan.
NOTE: Electric connections should be in
accordance with the National Electrical Codes and
all Local Codes. Before starting, disconnect power
to the circuit at the fuse box or circuit breaker
panel.
Remove the Faceplate and Screws from the Existing
Wall Switch. Pull Switch out from Wall Outlet Box.
Determine the "Hot" Wire and the "Load" Wire and
disconnect these Wires from existing Control
(Figure 33).
Do not attempt to disconnect any Wires not already
connected to existing Control.
Skip to Section 7.7 if using a 3-way switch
installation.
SINGLE-POLE INSTALLATION
7.6
Disconnect Electrical Power to the Branch Circuit at the
Circuit Breaker or Fuse Box before attempting to install
the Ceiling Fan Wall Control into the Outlet Box.
Before installing Wall Control, place Wall Control in
"OFF" mode by pushing "ON/OFF" Switch to the "OFF"
position.
WARNING
!
Do not connect any neutral (white) wire to this control.
Incorrect wiring will damage this control.
Connect the Wall Control Black Wire with the Yellow
Label marked "To Power Supply" to the "Hot" Wire
in the Wall Box. Securely connect Wires with Wire
Connector (supplied) (Figure 34).
Connect the Wall Control Black Wire with Blue Label
marked "To Fan" to the "Load" (Black) Wire in the
Wall Box. Securely connect Wires with Wire Connector
(supplied) (Figure 34).
Connect the Wall Control Green Ground Wire to the
Bare Copper Wire or Green Ground Wire in the Wall
Box. Securely connect Wires with Wire Connector
(supplied) (Figure 34).
(Continued)
SCREWS
Figure 33
!
Check to see that all connections are tight and that no
bare wires are visible at the wire connectors.
Screw Wall Control into Wall Box using the supplied
screws. Leave Wall Control in "OFF" mode until fan
installation is completed.
The Wall Control is supplied with a White, Ivory, and
Almond color Switch Covers. Choose the finish that
best suits your needs and snap the Cover onto the Wall
Control (Figure 34).
Install Decorator Wall Plate using the two screws
provided with Wall Plate. Leave Wall Control in "OFF"
mode until fan installation is completed (Figure 34).
SCREWS (2)
SWITCH COVER
DECORATIVE WALL PLATE
Figure 34
21
OUTLET
WALL
BOX
SWITCH
FACEPLATE
WARNING
FAN/LIGHT WALL
CONTROL
NEUTRAL
WIRES
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF515
WALL
BOX