Emerson DORIAN ECO Manual Del Usuario página 5

3.1
Remove One of the Three #6-32 x 3/8" Pan Head Screw
with Lockwasher from the Fan Motor Hub (Figure 1).
Retain the #6-32 x 3/8" Pan Head Screw with
Lockwasher for future use.
Loosen the Two #6-32 x 3/8" Pan Head Screws with
Lockwashers (Figure 1).
3.2
Place the 2-pin Fan Motor Assembly Connector and all
Wiring Connectors through the large center hole of the
Light Fixture Adapter (Figure 2).
Position the Light Fixture Adapter Key Hole Slots onto
the Two loosened Screw Heads.
Rotate the Light Fixture Adapter Clockwise to engage
the Two Screws.
NOTE: Verify that the serrated washers are not
trapped between the Light Fixture Adapter and the
Fan Motor Hub.
Reinstall the previously removed #6-32 x 3/8" Pan Head
Screw with Lockwasher (Figure 2).
Retighten all Three #6-32 x 3/8" Pan Head Screws
with Lockwashers to securely attach the Light Fixture
Adapter to the Fan Motor Hub (Figure 2).
A spare #6-32 x 3/8" Pan Head Screw with Lockwasher
is in the hardware bag, if needed.
Carefully turn the partially assembled Ceiling Fan
right side up and position the Fan on the styrofoam in
preparation for additional assembly.
NOTE: The LED Light Fixture Shade will be
installed during the Final Assembly, after the
Ceiling Fan is Hung and Wired.
3. Ceiling Fan Assembly
Figure 1
Figure 2
5
REMOVE AND RETAIN
#6-32 x 3/8" PAN HEAD
SCREW WITH LOCKWASHER
FAN MOTOR
ASSEMBLY
LOOSEN #6-32 x 3/8"
PAN HEAD SCREWS
WITH LOCKWASHERS
(2)
emersonfans.com
Please contact 1-800-654-3545 for further assistance
ETL Model No.: CF515