Publicidad
Idiomas disponibles
Idiomas disponibles
3. Operation
3.4. Fan speed setting
Fri
83
Room
F
Cool
Set temp.
83
F
Mode
Temp.
Fan
F1
F2
F3
F4
Press the [F4] button to go through the fan speeds in the following order.
• The available fan speeds depend on the models of connected indoor
units.
Notes:
• The number of available fan speeds depends on the type of unit
connected.
• In the following cases, the actual fan speed generated by the unit
will differ from the speed shown on the remote controller display.
1. While the display is in "STAND BY" or "DEFROST" states.
2. When the temperature of the heat exchanger is low in the heating
mode.
(e.g. immediately after heating operation starts)
3. In HEAT mode, when room temperature is higher than the
temperature setting.
4. When the unit is in Drying mode.
3.5. HOLD setting
Fri
83
Room
F
Cool
Set temp.
Auto
83
F
Mode
Temp.
Fan
F1
F2
F3
F4
3.6. Navigating through the Main menu
<Accessing the Main menu>
F1
F2
F3
F4
Auto
Press the [SELECT/HOLD] button to
enable/disable the HOLD function.
If the HOLD function is enabled, the
following functions will be prohibited,
and
will appear.
• ON/OFF timer
• Auto-Off timer
• Weekly timer
• Automatic return to the preset
temperature
Press the [MENU] button.
The Main menu will appear.
<Item selection>
Menu screen
F1
F2
F3
F4
<Saving the settings>
OU silent mode
Mon
Tue Wed Thu Fri Sat Sun
Start
Stop
Silent
-
Setting display:
day
F1
F2
F3
F4
<Exiting the Main menu screen>
Fri
83
Room
F
Cool
Set temp.
83
F
Mode
Temp.
Fan
F1
F2
F3
F4
If no buttons are touched for 10 minutes, the screen will automatically
return to the Main display. Any settings that have not been saved will be
lost.
<Display of unsupported functions>
Title
Not available
Unsupported function
Return:
F1
F2
F3
F4
3.7. Ventilation
► For LOSSNAY combination
● The following 2 patterns of operation are available.
• Run the ventilator together with the indoor unit.
• Run the ventilator independently.
Note:
● With some model configurations, the fan on the indoor unit may come on even
when you set the ventilator to run independently.
Note (for IR wireless remote controller and RF thermostat):
● Running the ventilator independently is not available.
● No indication on the remote controller.
Press [F2] to move the cursor left.
Press [F3] to move the cursor right.
Cursor
Select the desired item, and press
the [SELECT/HOLD] button.
The screen to set the selected item
will appear.
Press the [RETURN] button to exit
the Main menu and return to the
Main display.
The message at left will appear if the
user selects a function not supported
by the corresponding indoor unit
model.
7
Publicidad
