Publicidad
Idiomas disponibles
Idiomas disponibles
2610049815 09-07-2017.qxp_US40 9/7/17 11:06 AM Page 6
extremely careful of dust disposal, materials
in fine particle form may be explosive.
Do not throw dust on an open fire. Fine
dust particles may burn explosively.
When performing sanding and surface
preparation
operations
connected to a dust collection and
extraction system be aware of the
materials creating the dust. Combustion
from mixture of varnishes, lacquers,
polyurethane, oil or water with dust particles
can occur if there is a static discharge,
electric spark, or excessive heat causing a
fire in the dust collection and extraction
system.
Do not use dust extraction for operations
that include burning, smoking or
smoldering items like hot ashes or
sparks. Fire inside the vacuum tank or bag
may occur. Dust may smolder and set
vacuum on fire long after work is completed.
Do not use dust extraction with explosive
dusts, varnish, polyurethane coatings,
cleaners, or oil-based paints.
motors create sparks which may ignite the
dust or fumes.
Do not use dust extraction when working
on metal.
Swarf from sanding, grinding or
cutting metal may be hot and may spark
which may melt plastic adaptors, vacuum
hoses, and may cause a fire inside the
vacuum tank or bag.
grinding, drilling, and other construction
activities contains chemicals known to
cause cancer, birth defects or other
reproductive harm. Some examples of
these chemicals are:
• Lead from lead-based paints,
• Crystalline silica from bricks and cement
and other masonry products, and
• Arsenic and chromium from chemically-
treated lumber.
Your risk from these exposures varies,
depending on how often you do this type of
work. To reduce your exposure to these
with
tool
Electric
Some dust created by
power sanding, sawing,
chemicals: work in a well ventilated area, and
work with approved safety equipment, such
as those dust masks that are specially
designed to filter out microscopic particles.
US510, US520 & US540 – Metal, Masonry
and Diamond Tile Wheels
Follow OSHA and ANSI
B7.1 standards. Use wheel
to cut only materials for which it is intended. Do
not use for wet cutting. Wear body apron and
gloves. Mount wheel with tool flanges provided.
Run-in for one minute before application. Do
not jam, twist or pinch wheel in workpiece or
apply excessive side pressure to wheel.
Kickback may occur if wheel is jammed. Do not
position your body in line with wheel. Do not
use near flammable materials or gases, fire or
explosion may result. Do not expose to water,
condensation or freezing. Do not touch wheel
immediately after use as it may still be hot.
Discard wheel if dropped, cracked or chipped.
In addition to the warnings for the US510,
US520 and US540 please refer to the
following warnings.
US500 & US600 – Wood Wheel & Wood
Flush Cut Wheel
Use wheel to cut only materials for which it is
intended. Mount wheel with tool flanges
provided. Do not jam, twist or pinch wheel in
work piece or apply excessive side pressure to
wheel. Kickback may occur if wheel is jammed.
control tool. Do not position
Use two hands to
your body in line with wheel. Do not touch
wheel immediately after use as it may still be
hot.
US400 – Paint & Rust Surface Prep Wheel
Do not use plastic cover with Zipsaw,
Auxiliary handle required. Do not use with
Dremel SawMax, Xshield 1 or Xshield 2.
Clean tool guard after use.
US410 – Diamond Surface Prep Wheel
Do not use plastic cover with Zipsaw,
Auxiliary handle required. Do not use with
Dremel SawMax. Clean tool guard after
use.
-6-
Publicidad
