JVC KD-ADV38 Manual De Instrucciones página 67

Symptoms
• Bluetooth device does not detect the unit.
• The unit does not detect the Bluetooth
device.
• The unit does not make pairing with the
Bluetooth device.
• Echo or noise occurs.
• Phone sound quality is poor.
• The sound is interrupted or skipped during
playback of a Bluetooth audio device.
• "New Device" cannot be selected for
"Bluetooth Audio."
• The connected audio device cannot be
controlled.
• "No Disc" appears on the monitor.
• "No Magazine" appears on the monitor.
• "Cannot play this disc Check the disc" appears
on the monitor.
• "Reset 08" appears on the monitor.
• "Reset 01" – "Reset 07" appears on the
monitor.
• The CD changer does not work at all.
Remedies/Causes
This unit can be connected with one Bluetooth cellular
phone and one Bluetooth audio device at a time.
While connecting a device, this unit cannot be detected
from another device. Disconnect currently connected device
and search again.
• Check the Bluetooth setting of the device.
• Search from the Bluetooth device. After the device
detects the unit, select <Open> on the unit to connect
the device. (☞ page 32)
• Enter the same PIN code for both the unit and target
device. If the PIN code of the device is not indicated on its
instructions, try "0000" or "1234."
• Select the device name from <Special Device>, then
try to connect again. (☞ page 33)
Adjust the microphone unit position.
• Reduce the distance between the unit and the Bluetooth
audio device.
• Move the car to place where you can get a better signal
reception.
• Reduce the distance between the unit and the Bluetooth
audio device.
• Disconnect the device connected for "Bluetooth Phone."
• Turn off, then turn on the unit.
• (When the sound is not yet restored,) connect the device
again.
Bluetooth audio device is being connected. To select "New
Device," disconnect it. (☞ page 33)
Check whether the connected audio device supports AVRCP
(Audio Video Remote Control Profile).
Insert a disc into the magazine.
Insert the magazine.
Disc does not include playable files. Replace the disc with
playable files.
Connect this unit and the CD changer correctly and press
the reset button of the CD changer.
Press the reset button of the CD changer.
Reset the unit. (☞ page 3)
67
REFERENCES