Publicidad
Idiomas disponibles
Idiomas disponibles
the mains, which has been installed and positioned in accordance with local electrical
rules and regulations.
The isolating switch must be of an approved model and provide 3 mm contact separation
-
on all poles (or on all active [phase] conductors if local wiring regulations allow this
variation of requirements).
The user can easily access the isolation switch with the induction hob installed.
-
If in doubt about the installation, seek advice from local building authorities and
-
regulations.
Use heat-resistant and easy-to-clean finishes (such as ceramic tiles) on the walls
-
surrounding the hob.
If the induction hob is installed near a cabinet or drawers, a thermal protection barrier
-
must be installed between the hob and the furniture.
When you have installed the induction hob, make sure that:
The power cord is not accessible through cabinet doors or drawers.
-
There is an adequate flow of fresh air from the exterior of the cabinet to the hob base.
-
If the hob is installed above drawers or cabinets, you must install a thermal protection
-
barrier under the hob base.
The isolation switch is easily accessible to the user.
-
Before attaching the fixing brackets:
You must place the unit on a stable and smooth surface (you can use the packaging). Do not
exert force on the controls protruding from the plate.
Before attaching the fixing brackets (Fig. 6):
Secure the brackets on the left and right side with screws as shown in the picture. Place the
induction hob on the pre-cut board.
Warning
The induction hob must be installed by qualified personnel or technicians. Never carry out
-
the operation by yourself.
Do not install the induction hob above refrigeration appliances, dishwashers, and tumble
-
dryers.
The hob must be installed in a manner that ensures the best heat radiation to obtain the
-
best results.
The wall and the area over the work surface must withstand the heat.
-
To avoid any damage, the bonding layer and the adhesive must be heat resistant.
-
You should not use steam cleaners.
-
This induction hob may only be connected to a power supply with a resistance of not
-
more than 0.427 ohm. If necessary, consult the service department for information on the
resistance of the power supply.
ENGLISH
BOLERO SQUAD I 2100
87
Publicidad
