Ryobi RY34422 Manual Del Operador página 12

TO ATTACH THE STRAIGHT SHAFT GRASS
DEFLECTOR — S430
See Figure 6.
 Remove the wing screw from the grass deflector.
 Insert the tab on the mounting bracket in the slot on the
grass deflector.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
WARNING:
Gasoline and its vapors are highly flammable and
explosive. To prevent serious personal injury and property
damage, handle it with care. Keep away from ignition
sources and open flames, handle outdoors only, do not
smoke and wipe up spills immediately.
FUELING AND REFUELING THE TRIMMER
 Clean surface around fuel cap to prevent contamination.
 Loosen fuel cap slowly by turning counterclockwise. Rest
the cap on a clean surface.
 Carefully pour fuel into the tank. Avoid spillage.
 Prior to replacing the fuel cap, clean and inspect the
gasket.
 Immediately replace fuel cap and hand tighten by turning
it clockwise. Wipe up any fuel spillage.
NOTE: It is normal for smoke to be emitted from a new
engine after first use.
All manuals and user guides at all-guides.com
ASSEMBLY
OPERATION
8 — English
 Align the screw hole in the mounting bracket with the
screw hole in the grass deflector.
 Insert the wing screw through the mounting bracket and
into the grass deflector.
 Tighten the screw securely.
WARNING:
Always shut off engine before fueling. Never add fuel to a
machine with a running or hot engine. Move at least 30 ft.
from refueling site before starting engine. Do not smoke
and stay away from open flames and sparks. Failure to
safely handle fuel could result in serious personal injury.
OXYGENATED FUELS
DO NOT USE E85 FUEL. IT WILL VOID YOUR WARRANTY.
NOTE: Fuel system damage or performance problems re-
sulting from the use of an oxygenated fuel containing more
than the percentages of oxygenates stated below are not
covered under warranty.
Ethanol. Gasoline containing up to 10% ethanol by volume
(commonly referred to as E10) is acceptable. E85 is not.
CAUTION:
Attempting to start the engine before it has been properly
filled with lubricant will result in equipment failure.
ADDING/CHECKING ENGINE LUBRICANT
See Figure 7.
Engine lubricant has a major influence on engine perfor-
mance and service life. This unit is shipped with Ryobi
4-cycle 20W50 engine lubricant. For best operating perfor-
mance, continued use of this lubricant is recommended.
NOTE: Always use a 4-stroke engine lubricant that meets
or exceeds the requirements for API service classification
SJ. SAE 30, 10W30, or 10W40 are all acceptable lubricants
to use in this product. Non-detergent or 2-stroke engine
lubricants will damage the engine and should not be used.
Check lubricant level before each use.
To add engine lubricant:
 Remove the cap and seal from lubricant bottle provided.
 Unscrew the oil cap/dipstick and remove.
 Using funnel provided, add entire bottle of engine lubricant
through oil fill hole.
 Reinstall the oil cap/dipstick and secure.