Publicidad
Idiomas disponibles
Idiomas disponibles
EN- Safety Instructions
• The appliance shall be installed by a
qualified person in accordance with the
regulations in force to keep the warranty
applicable. The manufacturer shall not be
held responsible for damages arising from
procedures carried out by unauthorized
persons which will also void the warranty.
• It is customer's responsibility to prepare
the location the appliance shall be placed
on and to have the electrical installation
prepared. Before calling Authorized
Service, make sure the electrical
infrastructure is suitable. If it is not, call a
qualified electrician and fitter to have the
required arrangements made.
• The rules specified in the local electrical
installation standards shall be followed
during the product installation.
• Before installing the appliance, remove
all materials and documents in it and
check for any damage on the appliance.
Do not have it installed if the appliance is
damaged.
• The product is heavy, carry the product
with at least two people.
• Disconnect electrical connections in the
area of installation before starting the
installation.
• Failing to install the screws and securing
equipment in accordance with the guide
may cause electrical danger.
• The parts of product may have sharp
surfaces. Use protective gloves for
installation.
• There may be a risk of fall if the product is
not fixed enough. Make sure all fixings are
securely fastened.
• The hood width must be at least equal to
the width of your hob.
• Dimensions given in installation diagrams
are in mm.
• The air to be expelled from the hood
should not be fed into a chimney used
by other appliances burning gas or other
fuels. (not applicable for appliances that
discharge air back into the room).
• Legislation regarding the evacuation of air
must be complied with.
• If the oil filters are not cleaned and
maintained regularly and the carbon filter
is not replaced although its lifetime is
over (approximately 4 months), there is a
possibility of causing fire.
Installation of the appliance
This installation manual describes two
different ways of installation based on the
flue type. You can determine the installation
method suitable for your house and observe
the following installation steps.
1- Installation with flue - the aspirated air is
transferred to the outdoor through a flue;
2- Installation with a carbon filter where
aspirated air will be transferred to the indoor
by passing through a carbon filter
Product dimensions and safety
measurements (Figure 1-2)
• Pay attention to the product dimensions.
Consider its suitability with your furniture.
(Figure 1)
• The height between the lower surface of
your hood and the upper surface of the
hob should not be less than 650 mm
for gas hobs and 500 mm for electrical
hobs. (Figure 2)
* In the installation pictures, a demonstration
was made on the gas hob as an example
and the size required to be left on the hob
was shown as 650 mm. If you have an
electrical hob, take this measurement as 500
mm as a reference.
The inspection and preparation of the
wall for the installation
• The wall on which the appliance will be
installed, should be capable of bearing the
appliance, upright and in a flat position.
• There must be no water, electricity and gas
connections on the installation wall and
around the holes to be drilled.
Electrical connection of the appliance
• This appliance has a two-mark power
cables and must be connected to the
mains through an electrical switch with a
gap of at least 3 mm between the bipolar
contact terminals. Have the electrical
connection done by a qualified electrician.
• Disconnect the appliance from the electric
connection before starting any work on the
electrical installation. Risk of electric shock.
• The appliance may only be connected
to the mains electricity connection by
an authorized and qualified person. The
manufacturer shall not be held responsible
for any damages that may occur as a result
of operations performed by unauthorized
persons.
• Install your appliance in a way that the
electrical connection (power outlet, plug)
can be easily reached after installation.
• If your product has plug, do not make
electrical connections by disconnecting the
plug during installation. Connections made
by cutting off render the product warranty
void and pose a danger to user safety.
9
Publicidad
