Publicidad
Idiomas disponibles
Idiomas disponibles
EN
If you start the chain saw with a new chain, have a
test for 2-3 minutes. A new chain gets longer after the
first use, examine the tension and tighten the chain if
necessary.
8.4
INSTALL THE BATTERY PACK
18
•
If the battery pack or charger is damaged, replace
the battery pack or the charger.
•
Stop the machine and wait until the motor stops
before you install or remove the battery pack.
•
Read and understand the instructions in the
battery and charger manual.
1. Align the ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment
until the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
8.5
REMOVE THE BATTERY PACK
1. Push and hold the battery release button (18).
2. Remove the battery pack from the machine.
9
OPERATION
Remove the battery pack and keep hands clear of the
lock out button when you move the machine.
Examine the chain tension before each use.
9.1
EXAMINE THE CHAIN OIL
Do not use the machine without sufficient chain oil.
1. Examine the oil level of the machine from the oil
indicator.
2. Add oil if necessary.
NOTE
WARNING
NOTE
IMPORTANT
NOTE
English
9.2
HOLD THE MACHINE
1. The grip area is within 100 mm behind the lock out
button.
2. Hold the chainsaw with your right hand on the rear
handle and left hand on the front handle.
3. Hold the handles with the thumbs and the fingers
around them.
4. Make sure that your left hand holds the front handle
and your thumb is below the handle.
9.3
OPERATE THE CHAIN BRAKE
Make sure that your hands are on the handles at all
times.
1. Start the machine.
2. Push the guard forward to engage the chain brake.
3. Pull the handle guard / chain brake backwards to
disengage the chain brake.
4. Call approved service center for repair before use if
•
The chain brake does not stop the chain
immediately.
•
The chain brake does not stay in the disengaged
position without aid.
9.4
START THE MACHINE
10
WARNING
Publicidad
