Zipper ZI-MD500HST Instrucciones De Servicio página 38

a. Move the throttle lever to the SLOW position.
b. Allow engine to idle for 1-2 minutes.
c. Turn engine switch to OFF "OFF".
d. Turn the fuel valve lever to OFF.
ATTENTION: Not move the choke lever to stop the engine to CHOKE. Risk of reignition or damage to
the engine!
NOTES
• The steering characteristics change proportional to the speed driven and the laden weight.
The lightly loaded machine can be steered with lighter lever operation. With higher loading of
the steering lever to control with higher pressure.
The highest loadings of the machine is according to the floor on which the machine is used to
•
adjust.
It is therefore recommended to drive on difficult tracks in a low gear and with caution. In such
•
situations, the machine to be driven over the entire range in a low gear.
Avoid sharp turns and frequent changes of direction when driving on the road, especially on
•
rough, tough terrain, which has many sharp, uneven areas, causing high friction.
• Although the machine has rubber tracks, please remember, to be careful when working under
adverse weather conditions (ice, rain and snow) or on soils where the machine could be un-
stable.
When the clutch lever is released, the machine is automatically braked and stops.
•
• If the machine is stopped on steep slopes, one of the tracks must be secured with a wedge.
13.4.4 Dump box lifting and lowering ZI-MD500HST
14 MAINTENANCE
The machine does not require intense maintenance. However, to ensure a long lifespan, we strongly
recommend following the upkeep and maintenance plan.
Repairs must be carried out by specialists! Use original ZIPPER parts only!
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
• Pull the locking plate to the direction A and unlock the tip-
ping handle.
• To raise the dump box, pull the tipping handle up to the di-
rection B. The hydraulic system operates raising the dump
box.
• To lower the dump box, pull the tipping handle down to the
direction C. The hydraulic system operations lowering the
dump box.
• When the dump box is lowered in original position lock the
tipping handle with the locking plate.
C AU TI O N
No cleaning, upkeep, checks or maintenance when machine is running.
Shut off the machine and let it cool down before start servicing!
MAINTENANCE
38
ZI-MD500HST