Zipper ZI-MD500HST Instrucciones De Servicio página 40

14.3.2 Check hydraulic oil
Waste oils are toxic and must not be released into the environment!
Contact your local authorities for information on proper disposal.
14.4 Gearbox
14.4.1 Check gearbox oil
The gearbox is pre-lubricated and sealed at the factory. Unless there is evidence of leakage or service
has been performed on the gearbox, no additional lubricate should be required until 50 hours of use.
For future use, check the oil level after every 50 hours of use.
ZIPPER MASCHINEN GmbH www.zipper-maschinen.at
1. Remove the oil drain plug (1) from the engine.
2. Open the oil tank cap (2). Collect the draining oil in a col-
lection container and dispose of it properly.
3. Retighten the oil drain plug after draining.
4. Fill in fresh oil through the filling opening (3) (see section
Checking the engine oil level).
Use only high quality engine oil, e.g: SAE30, 15W40 or
similar!
Drain the used oil when the engine is warm. Warm
oil drains quickly and completely.
N O TE
1. Loosen the hydraulic pipe (2) to drain the old hydraulic oil
into a suitable container.
2. After the hydraulic oil tank has been completely emptied,
retighten the hydraulic pipe (2).
3. Remove the oil dipstick (1) and add the oil.
The recommended hydraulic oil is 10W AW32, ASLE H-150
or HLP 32.
Oil capacity of the hydraulic system: see technical data.
4. Check the correct oil level by means of the marking (3) on
the dipstick after filling.
MAINTENANCE
N O TE
40
ZI-MD500HST