GASPARDO FIORE Serie Empleo Y Mantenimiento página 46

ENGLISH
4.4 CARDAN SHAFT ADAPTION
SLIPPAGE OF THE PTO SHAFT.
Inspections at work:
Telescoping tubes must always overlap by at least 1/2 of their
length in normal operation and at least 1/3 of their length in
all working conditions. During maneuvers, when the driveline
is not rotating, the telescoping tubes must have a suitable
overlap to maintain the tubes aligned and allow then to slide
freely.
46
USE AND MAINTENANCE
Inspections in the raised position:
If these two results are not obtained:
A
C
L min.
4 cm
4 cm 4 cm
L min.
B
D
cod. G19503900