Gaggia La Precisa EL1 Uso Y Mantenimiento página 60

English
Before proceeding with installation check that:
• there are no bumps, signs of knocks or deformities
• there are no damp patches or marks which could lead one to assume that the packaging has been exposed to the elements
• there are no signs of tampering
Once one is satisfied that transportation has been correctly effected, proceed with installation.
Make sure the appliance is installed on a flat surface capable
of bearing its weight (see "Technical specifications" chapter)
and take care of leaving a clear area of at least 30 cm
around the machine.
The least height of the support's top must be 110 cm (the
highest surface of the appliance shall however be at least
1.5 m from the ground level).
the gradient of the supporting surface should NOT exceed
2°;
Proceed with installation following the instructions according to the sequence as described below.
Machine underside view
ITCA Water filling tube inlet
ICAE Electrical power cord inlet
ATS Drain pipe connector
60