Gaggia La Precisa EL1 Uso Y Mantenimiento página 78

English
During the washing cycle
of a group, it is possible to
normally use the other
groups.
It is possible to carry out
simultaneous
cycles of different groups.
8.2.2.2 Cleaning filter holder cup
Carry out this operation
on all filter holders.
Pour hot water (50÷80°C) and some detergent in a
container, following the indications of the product.
Use detergents authorised
by the manufacturer.
Remove the filter (E2) from the filter holder (F2), immerse
the filter and the filter holder in the solution for some
minutes, remove any residuals and then rinse them.
Insert the filter (E2) in the filter holder (F2).
78
Immerse only the metal
part of the filter holder in
the solution.
8.2.2.3 Cleaning spout
Prize the spout (D2) by means of a proper tool and take
care not to damage the group seal (B2).
washing
Danger of burning. Before
making any intervention,
make sure the temperature
of the spout is not too
high.
Separate the group seal (B2) from the spout (E2), immerse
them in the detergent solution for some minutes, remove
any residuals and then rinse them.
Clean the seat of the spout (E2) by means of the supplied
brush.
Press the spout (E2), complete with the seal (B2), to
reinsert it into the coffee group.