Publicidad
Idiomas disponibles
Idiomas disponibles
NAME OF PARTS
4 NAME OF PARTS
•
This controller is used to send commands about operation
mode, timer setting, etc. to the indoor unit. Face the
transmitter of the controller toward the receiver of the indoor
unit and press the switch of required operation so that
commands (by infrared rays) are sent to the indoor unit.
•
The distance for transmitting is approximately 6 meters as
a maximum. (The capable distance for transmitting will get
shorter in case that the transmitting angle is not vertical to
the receiver or an electronic type light is used in the room,
etc.).
•
Use the combination of the receiver kit and the indoor unit
which are supported this controller.
Reset switch
Transmitter
Point the transmitter towards the receiver of the indoor unit when
sending commands. The transmitting indication on the liquid crystal
display flashes when sending commands.
Transmitting indication: It will turn ON when sending commands by
infrared rays.
2
PMML0414A rev.2 - 11/2016 - P5416676
Liquid crystal display
The set temperature, timer operation, position of air louver,
operation mode, air flow mode, etc., are indicated. The diagram of
the display shown on the left is for explanation purposes only. The
display will differ during actual operation.
Fan speed switch
Press this switch to select the fan speed. By repeatedly pressing
the button, the setting will change sequentially through LOW, MED,
HIGH, and HIGH2 (AUTO not available).
LOW
o
On switch
p
Operation of the unit can be started by pressing this switch.
q
Off switch
r
Operation of the unit can be stopped by pressing this switch.
Mode Selection Switch
By repeatedly pressing the mode switch, the unit cycles through the
different operating modes in the order of FAN, COOL, HEAT, AUTO.
s
Depending on the setting for selecting the function, it is possible to
set the ON/OFF for AUTO, HEAT and DRY display.
Louver angle switch
The airflow angle and auto-louver operation can be set by this
switch. When pressing the switch, the angle is changed in the
following order. (In COOL or HEAT or AUTO operation modes, steps
1-5 and Auto swing are available.)
1 step
2 step
t
u
Filter sign reset switch
This switch is used to turn off the filter indication lamp of the indoor
v
unit, which is turned on when it is required to clean the filter. The
alarm sound can be cancelled temporarily by pressing the button.
Temperature switch
The setting temperature can be adjusted using this switch.
w
By pressing "▲", the temperature will increase by 1ºC, 1ºF at a time.
x
By pressing "▼", the temperature will decrease by 1ºC, 1ºF at a
time.
Timer switches
Used to set the timer.
y
The set time can be changed by pressing "On timer" or "Off timer".
The timer can be set from 0.5 to 23 hours. When 0.5 to 9.5 hours,
the unit will set as 30 min. at a time, and when 10 to 23 hours, the
unit will be set as 1 hour at a time.
z
?
N O T E
When the wireless controller is prohibited by central controller, this
functionisdisabledeventhoughtheindoorunitissetwiththewireless
controller and the buzzer sounds.
MED
HIGH
HIGH2
(not available)
3 step
4 step
5 step
6 step
AUTO
7 step
8 step
Publicidad
