Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
1 Press both "On Timer" and "Reset" 3 seconds.
2 The current value set for this function will be displayed (A, B).
3 Press " " to change the setting in ascending order. (
Press " " to change the setting in descending order. (
?
N O T E
Thesettingwillberecordedeachtime"
4 Press "
Off " switch to exit this function and reset.
?
N O T E
Ifnooperationisperformed30secondsafterthisfunctionisdisplayed,itwillautomaticallyendandreset.
7 OPERATION
When operating the controller, face the transmitter toward the
receiver of the indoor unit and press the switch for the required
operation as described in the item
FROMCONTROLLER".
8 INSTALLING ONTO THE WALL OR PILLAR
!
C A U T I O N
Whenthecommandsaresentbythecontrollerhookedontothewall,the
receiveroftheindoorunitmaynotreceivethecommandsdependingon
the installation
place.
1 Select the suitable place for handling and install the
controller with the customer's acceptance. Do not install the
controller at the places as follows.
-
where children can touch
-
where the air from the air conditioner is directly
discharged
-
where there is oil vapor and the oil is dispersed
-
where the humidity is high
2 Pay attention to the following points in case that the
controller is installed in a place where there is medical
equipment radiating electromagnetic waves.
a. Install the controller in a place where electromagnetic
waves are not radiated directly toward the electrical box
of the indoor unit and the controller.
b. Keep a distance more than 3 meters away from the
equipment radiating electromagnetic waves, the receiver
of the radio, etc. for prevention of the noise through the
air.
c. In case that there is electric noise at the power source for
the indoor unit, the treatment such as providing a noise
filter is required.
4
PMML0414A rev.2 - 11/2016 - P5416676
A Mode (A)
A → B
A ← B
On"switchispressed.
"5SENDINGCOMMANDS
B Mode (b)
)
)
!
C A U T I O N
•
Incasethattwoindoorunitsareinstalledsidebyside,thecommands
fromthecontrollermaybereceivedbybothindoorunits.Thefunction
toidentifyeachindoorunitnotapplicable.
•
Theitemidentifyingindoorunitsinstalledsidebysideoperationshall
be set if recognition is required.
3 Do not install the controller in a place where generation,
flowing, staying or leaking of flammable gas is detected.
4 Install the controller in a place where there is a distance
more than 30cm from the power supply cable when installing
the controller onto the wall.
5 Install the holding bracket (accessory) onto the wall by using
screw (accessory) and attach the controller to the holding
bracket.
Screws
Holding Bracket
Publicidad
