TEST RUNNING BY CONTROLLER
10 TEST RUNNING BY CONTROLLER
!
C A U T I O N
Testrunningbythecontrollercannotbeperformedincasethatthewired
remote control switch is used together; in case that multiple units are
operatedsimultaneously(SET-FREEandUTOPIAseries).Insuchcases,
performthetestrunningbythewiredremotecontrolswitch.
1 Perform the test run after the installation work is completed.
a. Set the batteries for the controller.
b. Turn ON the power supply for the indoor and outdoor
units.
c. "
" lamp (yellow) on the receiver of the indoor unit
flashes (0.25 seconds ON
then turns OFF. While the lamp is flashing, the unit will
not operate because it is initializing.
2 Set the test run mode by pressing "LOUVER" and "ON
TIMER" switch simultaneously for more than 3 seconds. The
LCD should be as shown in the figure on the below.
3 Set the operation mode by pressing the "MODE" switch.
4 Operate the test run by pointing the transmitter towards
the receiver of the indoor unit and press the "
When the commands are received by the indoor unit, the
"
" lamp (yellow) of the receiver will come on briefly. Check
the commands are received well and the mode selected 3) is
set correctly.
In the test run mode, the red lamp (RUN) of the receiver
is turned ON and the green lamp (TIMER) flashes (0.5
seconds ON
0.5 seconds OFF) (*2). And then set off
timer for 2 hours.
6
PMML0414A rev.2 - 11/2016 - P5416676
0.25 seconds OFF), and
Test run mode is
under suspension
Test run mode is
under operating
On" switch.
?
N O T E
•
In the case that the "
" lamp(yellow)doesnotturnON,thecontrols
maynothavereachedthereceiver.Sendthecommandsagain.
•
(*2)InthecaseofRPKmodel,"TIMER"lampisturnedONwithout
flashing.
5 Adjust the angle of the air louver as follows.
Check the commands are received correctly using the lamp
and buzzer of the receiver kit. Use the wireless remote
controller pointing the transmitter toward the receiver.
!
C A U T I O N
Theairlouverhasamechanismfortheauto-swingfunction.Donotmove
thelouverbyhandforcefully.
a. Select the FAN mode by pressing the 'MODE' switch.
b. Set the louver angle by pressing the 'LOUVER' switch.
The louver direction is changed as follows. (For heating
and fan operation).
LCD Indication
6 Stop the test run
a. Test run is stopped after 2 hours automatically.
b. Test run is stopped by pressing "
After Test Run is finished, check that the red lamp (RUN)
and the green lamp (TIMER) are turned OFF.
Off" switch.