Publicidad
Insert the appliance plug into the bottom of the appliance and put
the adapter in the wall socket.
The charging light goes on and stays on to indicate that the
,
appliance is charging.
The charging light does not go out or change colour when the
appliance is fully charged.
optimising the lifetime of the batteries
-
After you have charged the appliance for the first time, do not
recharge it between epilating or shaving sessions. Continue to use it
and only recharge it when the battery is (almost) empty.
-
Discharge the batteries completely twice a year by letting the motor
run until it stops.
-
Do not keep the appliance plugged into a wall socket all the time.
-
If the appliance has not been used for a long time, it must be
recharged for 16 hours.
Preparing for use
Freezing the leg skin cooler
1
Put the skin cooler WITHOUT the insulating sleeve in the freezer
or freezing compartment (***) at least hours before you start to
epilate. When the fluid has turned completely blue, the skin cooler
is ready for use.
Make sure the outside of the skin cooler is completely dry before you
freeze it.
Tip: You can store the skin cooler in the freezer permanently.
using the appliance
general information about epilation
Epilation is easier just after a bath or shower. Make sure your skin
,
is completely dry when you start to epilate.
All manuals and user guides at all-guides.com
EnglisH
Publicidad
