Fronius MTG 250d Manual De Instrucciones página 40

MTG d, MTW d, MHP d - General
Up/Down func-
tion
JobMaster func- IMPORTANT! Coded messages can appear on the JobMaster.
tion
These correspond to the service code displayed on the control panel at the same
time (see the "Troubleshooting" section of the power source operating instruc-
tions).
SynchroPulse (option) - no symbol lights up on the JobMaster (see the
"MIG/MAG welding" section of the power source operating instructions).
1
40
- Select one of the following para-
meters on the power source:
- Wire feed speed
- Job number
- Set the parameters using the Up/
Down function
IMPORTANT! In the "MIG/MAG Stan-
dard Synergic and Pulse Synergic Wel-
ding" operating modes, extra parame-
ters can be set.
2