Fronius MTG 250d Manual De Instrucciones página 46

Fitting the ML torch body to the MHP hosepack
Assembling the
NOTE!
Multilock wel-
ding torch Risk of damage to the welding torch. Always tighten the union nut on the torch
body as far as it will go.
NOTE!
In the case of water-cooled welding torches, increased resistance may arise
when tightening the union nut due to the construction of the welding torch. This
is normal. Always tighten the union nut on the torch body as far as it will go.
NOTE!
Before fitting a torch body, ensure that the interface between the torch body
and the hosepack is clean and undamaged.
1
2
*
46
(A) (B)
(A)
(B)
Ensure that the union nut is tightened as far as it will go.
NOTE!
The torch body is in the 0° position
when the dowel pin (A) on the ho-
sepack engages in the locating hole
(B) in the torch body.
3