JVC KD-X262 Manual De Instrucciones página 16

AUDIO SETTINGS
[SUBWOOFER SET]*3 [ON]: Turns on the subwoofer output. ; [OFF]: Cancels.
[SUBWOOFER LPF]*1 [FRQ THROUGH]: All signals are sent to the subwoofer. ;
[FRQ 55HZ]/[FRQ 85HZ]/[FRQ 120HZ]: Audio signals with frequencies
lower than 55 Hz/85 Hz/120 Hz are sent to the subwoofer.
[SUB.W PHASE]*1*4 [REVERSE] (180°)/[NORMAL] (0°): Selects the phase of the subwoofer
output to be in line with the speaker output for optimum performance.
[FADER] [POSITION R06] to [POSITION F06] ([POSITION 00]): Adjusts the front
and rear speaker output balance.
[BALANCE]*5 [POSITION L06] to [POSITION R06] ([POSITION 00]): Adjusts the left
and right speaker output balance.
[VOLUME ADJUST] [LEVEL –15] to [LEVEL +06] ([LEVEL 00]): Presets the initial volume
level of each source by comparing to the FM volume level. (Before
adjustment, select the source you want to adjust. "VOL ADJ FIX" appears
if FM is selected.)
[AMP GAIN] [LOW POWER]: Limits the maximum volume level to 25. (Select if the
maximum power of each speaker is less than 50 W to prevent damaging
the speakers.) ; [HIGH POWER]: The maximum volume level is 35.
[D.T.EXPANDER] [ON]: Creates realistic sound by compensating the high-frequency
(Digital Track components and restoring the rise-time of the waveform that are lost in
Expander) audio data compression. ; [OFF]: Cancels.
[SPK/PRE OUT] Depending on the speaker connection method, select the appropriate
setting for the desired output. (See "Speaker output settings".)
*1 Displayed only when [SUBWOOFER SET] is set to [ON].
*2 Displayed only when [SPK/PRE OUT] is set to [SUB.W/SUB.W].
*3 Displayed only when [SPK/PRE OUT] is set to [REAR/SUB.W] or [SUB.W/SUB.W].
*4 Selectable only if a setting other than [FRQ THROUGH] is selected for [SUBWOOFER LPF].
*5 This adjustment will not affect the subwoofer output.
12
ENGLISH
Speaker output settings
[SPK/PRE OUT]
Select the output setting for the speakers [SPK/PRE OUT], based on the speaker
connection method.
Connection via lineout terminals
For connections through an external amplifier. (Page 19)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] (default) Subwoofer output
[SUB.W/SUB.W] Subwoofer output
Connection via speaker leads
You can also connect the speakers without using an external amplifier
but still being able to enjoy the subwoofer output with these settings.
(Page 19)
Setting on
[SPK/PRE OUT]
[REAR/REAR] Rear speakers output
[REAR/SUB.W] Rear speakers output
[SUB.W/SUB.W] Subwoofer output
If [SUB.W/SUB.W] is selected:
– [FRQ 120HZ] is selected in [SUBWOOFER LPF] and [FRQ THROUGH] is not available.
– [POSITION R01] is selected in [FADER] and selectable range is [POSITION R06] to
[POSITION 00].
Audio signal through lineout terminal
REAR/SW
Audio signal through rear speaker lead
L (left) R (right)
Rear speakers output
Rear speakers output
(Mute)