Troubleshooting - JVC KD-X262 Manual De Instrucciones

TROUBLESHOOTING

Symptom
Sound cannot be heard. • Adjust the volume to the optimum level.
• Check the cords and connections.
"MISWIRING CHECK WIRING
THEN PWR ON" appears.
"PROTECTING SEND SERVICE"
appears.
Source cannot be selected.
The unit does not work at all.
Correct characters are not • This unit can only display uppercase letters, numbers,
displayed.
• Depending on the display language you have selected
• Radio reception is poor.
• Static noise while listening
to the radio.
Playback order is not as
intended.
Elapsed playing time is not
correct.
"NOT SUPPORT" appears and
track skips.
"READING" keeps flashing. • Do not use too many hierarchical levels and folders.
• Reattach the device (USB/iPod/iPhone).
16
ENGLISH
Remedy
Turn the power off, then check to be sure the terminals of
the speaker wires are insulated properly. Turn the power
on again.
Send the unit to the nearest service center.
Check the [SOURCE SELECT] setting. (Page 5)
Reset the unit. (Page 3 or 4)
and a limited number of symbols.
(page 6), some characters may not be displayed
correctly.
Connect the antenna firmly.
The playback order is determined by the file name (USB).
This depends on the recording process earlier (USB).
Check whether the track is a playable format.
(Page 14, 15)
Symptom Remedy
"CANNOT PLAY" flashes and/ • Check whether the connected device is compatible with
or connected device cannot this unit and ensure the files are in supported formats.
be detected (Page 14, 15)
• Reattach the device.
The iPod/iPhone does not • Check the connection between this unit and iPod/iPhone.
turn on or does not work. • Disconnect and reset the iPod/iPhone using hard reset.
"NO DEVICE" Connect a device (USB/iPod/iPhone), and change the
source to USB/iPod/iPhone again.
• Sound cannot be heard • Reconnect the Android device.
during playback. • Launch any media player application on the Android
• Sound output only from device and start playback.
the Android device. • Relaunch the current media player application or use
another media player application.
• Restart the Android device.
• If this does not solve the problem, the connected Android
device is unable to route the audio signal to unit.
(Page 15)
• If USB connection does not work, connect the Android
device through auxiliary input jack.
"NO DEVICE" or "READING" • Reconnect the Android device.
keeps flashing. • If USB connection does not work, connect the Android
device through auxiliary input jack.
Playback is intermittent or Turn off the power saving mode on the Android device.
sound skips.
"CANNOT PLAY" • Make sure Android device contains playable audio files.
• Reconnect the Android device.
• Restart the Android device.
If you still have troubles, reset the unit. (Page 3 or 4)