Epson TM-H6000II Manual Del Usuario página 12

EMC and Safety Standards Applied
Product Name: TM-H6000II with Image Scanner
Model Name: M147E/M147F
The following standards are applied only to the
printers that are so labeled. (EMC is tested using
the EPSON power supplies.)
Europe: CE marking
Safety: EN 60950
North America: EMI:
Safety: UL 1950/CSA C22.2
Japan: EMC: VCCI Class A
Oceania: EMC: AS/NZS 3548
WARNING
The connection of a non-shielded printer interface
cable to this printer will invalidate the EMC
standards of this device.
You are cautioned that changes or modifications not
expressly approved by Seiko Epson Corporation
could void your authority to operate the equipment.
CE Marking
The printer conforms to the following Directives
and Norms:
Directive 89/336/EEC
Important Safety Information
This section presents important information intended to ensure safe
and effective use of this product. Read this section carefully and store
it in an accessible location.
Key to Symbols
The symbols in this manual are identified by their level of importance, as
defined below. Read the following carefully before handling the product.
WARNING:
Warnings must be followed carefully to avoid serious bodily injury.
2 TM-H6000II with Image Scanner User's Manual
FCC/ICES-003 Class A
No. 950
M147E: Class A
M147F: Class A
EN 55022
M147E: Class A
M147F: Class A
EN 55024
IEC 61000-4-2
IEC 61000-4-3
IEC 61000-4-4
IEC 61000-4-5
IEC 61000-4-6
IEC 61000-4-8
IEC 61000-4-11
WARNING
M147E/M147F is a Class A product. In a domestic
environment this product may cause radio
interference in which case the user may be
required to take adequate measures.
FCC Compliance Statement For
American Users
This equipment has been tested and found to
comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference when the equipment
is operated in a commercial environment.
This equipment generates, uses, and can radiate
radio frequency energy and, if not installed and
used in accordance with the instruction manual,
may cause harmful interference to radio
communications.
Operation of this equipment in a residential area is
likely to cause harmful interference, in which case
the user will be required to correct the interference
at his own expense.
For Canadian Users
This Class A digital apparatus complies with
Canadian ICES-003.