Axis Q1615-E Mk II Guia De Instalacion página 16

AXIS Q1615-E Mk II Network Camera
Status LED behavior and buzzer signal for leveling assistant
For information on the function button used for leveling the camera, see page 18.
Press and hold the function button (2) for more than two seconds to level the camera.
• When the camera is level, both LEDs are steady green, and the beep is continuous.
• When the camera is not level, the LEDs flash a combination of red, green and orange, and
the beep occurs at slow intervals.
Both LEDs briefly flash green to indicate that the leveling is getting better.
SD card slot
NO TICE TICE
NO NO TICE
• Risk of damage to SD card. Do not use sharp tools, metal objects or excessive force when
inserting or removing the SD card. Use your fingers to insert and remove the card.
• Risk of data loss and corrupted recordings. Do not remove the SD card while the product
is running. Disconnect power or unmount the SD card from the Axis product's webpages
before removal.
This product supports microSD/microSDHC/microSDXC cards (not included).
For SD card recommendations, see www.axis.com
Connectors
Network connector
RJ45 Ethernet connector with Power over Ethernet (PoE).
NO NO TICE NO TICE TICE
Due to local regulations or the environmental and electrical conditions in which the product
is to be used, a shielded network cable (STP) may be appropriate or required. All cables
connecting the product to the network and that are routed outdoors or in demanding
electrical environments shall be intended for their specific use. Make sure that the network
devices are installed in accordance with the manufacturer's instructions. For information
about regulatory requirements, see Electromagnetic compatibility (EMC) on page 4.
I/O connector
Use with external devices in combination with, for example, tampering alarms, motion detection,
event triggering, and alarm notifications. In addition to the 0 V DC reference point and power (DC
output), the I/O connector provides the interface to:
• Digital output – For connecting external devices such as relays and LEDs. Connected
devices can be activated by the VAPIX® Application Programming Interface, output
16