Axis Q1615-E Mk II Guia De Instalacion página 26

AXIS Q1615-E Mk II Network Camera
Adjust focus and zoom for optional lenses
If the camera is mounted so that you cannot look at the image and access the lens at the same
time, use the Focus Assistant, see Focus assistant for optional lenses on page 26.
1. Open the product's home page and go to Setup > Basic Setup > Focus.
2. Under the Basic tab, click Open iris. If the button is inactive the iris is already open.
3. If focus has been set before, click Reset to reset the back focus.
4. Loosen the zoom and focus pullers on the lens by turning them counter-clockwise.
5. Loosen the zoom puller and the lock screw for the focus ring on the lens by turning
them counter-clockwise.
6. Move the pullers to set zoom and focus and check the quality of the image in the image
window.
7. Move the zoom puller and the focus ring to set zoom and focus and check the quality of
the image in the image window.
8. Re-tighten the zoom and focus pullers.
9. Re-tighten the zoom puller and the lock screw for the focus ring.
10. On the Focus page, click Fine-tune focus automatically and wait until automatic fine
tuning is completed.
11. Click Enable iris. If the button is inactive the iris is already enabled.
12. If needed, make further adjustments under the Advanced tab. See the online help for
more information.
Focus assistant for optional lenses
Note
• The view in front of the camera should not be changed during focus adjustment (steps
5 and 6). If the camera is moved, or if a finger or other object is placed in front of the
lens, steps 3–7 will have to be repeated.
• If movements in front of the camera cannot be avoided, the Focus Assistant should not
be used.
• f the camera is mounted so that the function button cannot be accessed, you can still
use the Focus Assistant. Follow the instructions below but mount the camera after step
4, pressing the function button instead and skip step 7.
To focus your network camera using the Focus Assistant, follow steps 1–3 underAdjust focus and
zoom for included lens on page 24 before you start with the steps below.
1. Mount or place the camera so that it cannot be moved.
2. Loosen the zoom puller by turning it counter-clockwise. Move the puller to set the
zoom level. Re-tighten the zoom puller.
3. Set the camera to its extreme distant-focus position by loosening the lock screw for the
focus ring and turning the focus ring fully counter-clockwise.
26