Publicidad
Idiomas disponibles
Idiomas disponibles
permanently watertight.
Congratulations, the installation is
complete.
The inverter and WLAN module will
take a few seconds to boot up. Please
follow the respective installation guide
on how to access the inverter.
Connecting to the Lidl Home
app
The inverter can be connected to the Lidl
Home app.
1.
Also see the section "Activating/
deactivating Bluetooth".
2.
Enable Bluetooth on your smartphone.
3.
Open the Lidl Home App. From here
there are options
connect the inverter.
If the inverter is the first device you want
to connect to the app:
4.
On the
tab, select the option „Add
device". The app scans the area
for available devices and indicates if
available devices have been found. If
this is not the case, read on if possible
.
5.
If you select „ADD DEVICE", the
available devices are displayed in a
list.
6.
Select the inverter by setting the check
mark
. Select only one device at a
time. If there are other check marks for
other devices, clear the check marks by
pressing them.
7.
Select the WiFi network your
smartphone connect and enter the
password (only supports 2.4G router
network).
8.
Confirm the successful connection with
,
and
to
„Done". The inverter is now listed in
the
tab and is connected.
If you have already connected other
devices to the app:
4.
On the
tab , select the
upper right. The app scans the area
for available devices and indicates if
available devices have been found.
If this is not the case, read on if
possible
.
5. Proceed as with
If a list of available devices is not
automatically suggested to you:
If the inverter is not suggested automatically,
follow these steps:
4.
On the tab
upper right.
5.
Select „Others" in the bar on the left.
6.
Select „Others-1".
7.
Select the Wi-Fi network your
smartphone connect and enter the
password then press"NEXT"
8.
Switch to the "AP mode" by choosing
at the upper right menu "
the Wi-Fi LED status on the inverter
and press „Confirm the indictor is
blinking slowly" if with yes answer.
9.
Now connect to the device's hotspot.
The device will be connect in 2 minutes.
Upgrading the firmware can change
the features of the app.
Activating/ deactivating Bluetooth
To activate Bluetooth, make sure the inverter
is on power.
If the indicator isn't blinking, please start the
reset step:
1.
Power on the device;
in the
from point 5.
, select the
in the
". Check
25
Publicidad
