ATTACHMENTS ON HANDLE
NOTE:
If the floor nozzle is attached,
turn vacuum cleaner off before removing
handle from wand.
1. Press wand release button and pull up on
handle.
2. Slide attachments onto handle as
needed. To use the bare floor brush,
align the middle hole on the floor brush
with the tab on the handle and push
onto together. The bare floor brush will
click into place. See ATTACHMENT USE
TABLE (page 15).
ATTACHMENTS
ATTACHMENTS ON WAND
1. To remove floor nozzle from wand, press
the nozzle release button and pull to
remove.
2. Slide attachments onto wand as needed.
To use the bare floor brush, align the
side hole on the floor brush with the tab
on the wand and push onto together. The
bare floor brush will click into place. See
ATTACHMENT USE TABLE (page 15).
- 14 -
Nozzle
Release
Button