Hoshizaki DCM-120FE Manual De Instrucciones página 4

* Water should drain into an open trap.
* There should be no backflow in the water circuit.
) By means of a suitable spanner or wrench,
tighten the /2-3/4 nipple (accessory) into the
Rc1/2 fitting at the bottom of the ice dispenser
as indicated. P.T.F.E. tape and/or a suitable
sealing compound should be used to obtain a
leak free joint.
Note: Jointing compounds should be approved
and suitable for potable water use.
2) Attach the angled end of the white flexible inlet
hose (accessory) to free end of /2-3/4 nipple
ensuring rubber sealing washer is correctly
positioned. Hand tighten sufficiently to provide a
leak free joint.
3) Attach the other end of the inlet hose to the
water tap, noting washer is correctly positioned
before hand tightening as above.
4) Attach the grey flexible drain hose (accessory)
to the R3/4 fitting at the bottom of the Drain Pan,
confirming fitment of rubber washer before finally
hand tightening the joint. P.T.F.E. tape and/or
a suitable sealing compound should be used
to obtain a leak free joint. The pipe can be cut
to length as necessary to suit position of main
drain.
Water Supply
Inlet Rc/2
Inlet Hose
/2-3/4 Nipple
Fig. 2
All manuals and user guides at all-guides.com
Drain Outlet
R3/4
Drain Hose
Water Supply Tap
Inlet Hose
Fig. 3
3
II. OPERATING INSTRUCTIONS
WARNING
. This ice dispenser is designed to produce
and store edible ice. To keep the ice
dispenser hygienic:
* Keep the Grille in the Drain Pan clean.
Clean it by using a neutral cleaner and
rinse thoroughly.
2. The use of any electrical equipment
i n v o l v e s t h e o b s e r v a n c e o f s o m e
fundamental rules. In particular:
* Instances of high humidity and moisture
increase the risk of electrical short circuits
and potential electrical shocks. If in
doubt, disconnect the ice dispenser.
* Do not pull the power cord in order to
disconnect the ice dispenser from the
feed network.
* T h i s a p p l i a n c e i s n o t s u i t a b l e f o r
unsupervised use by young children or
aged or infirm persons.
3. All parts are factory-adjusted. Improper
adjustments may result in failure.
4. If the unit is turned off, wait for at least 3
minutes before restarting the ice dispenser
to prevent damage to the Compressor.
5. Periods of 5 to 6 hours without dispensing
ice could result in wet ice or an ice bridge
forming in the Storage Bin. Always turn
off the Ice Making Switch, and remove
ice from the Storage Bin within 2 hours.
Soggy and sticky ice should be removed
continuously as produced.
6. This ice dispenser is programmed to
suspend ice dispensing action when the
Push Lever is continuously pressed for
more than 2 minutes. Also, pressing and
releasing the Push Lever repeatedly for
extended periods may cause the protector
to stop the ice dispenser.
IMPORTANT
. To prevent ice and/or water from scattering
or splashing, use a container with more
than a 7 cm opening. Place the container
about  cm below the Spout when pressing
the Push Lever to dispense ice and/or
water.
2. Clean out the Storage Bin once a day, or
stored ice may melt and refreeze, causing
ENGLISH