Volkswagen 5NA 092 101 Instrucciones De Montaje página 34

Position the rubber grommet fitted to the wiring harness and insert into the opening hole from the
luggage compartment to the outside. Ensure that it is correctly seated.
Fasten the wiring harness at the intended position on the edge of the rear body panel plate using the
white clip and use the supplied 377 mm cable ties to affix it to the towing hitch cross-member.
Insert the three 6-pin, 10-pin and 24-pin connector housings of the wiring harness into the intended
slots in the trailer connection unit and click into place. (See fig. 4)
Then insert the trailer connection unit at the intended position in the side panel at the rear on the left
and use the required parts (snap nut clamp and screw) to secure it in place. (See fig. 4)
Attach the supplied 193 mm cable ties with edge clip to the end of the plate edge at the rear left near
to the trailer connection unit and secure the wiring harness to it. (See fig. 4)
Figure 4:
Connect the four cable lugs of the brown wires in the 12-wire and 9-wire wiring harnesses to the
vehicle earthing point on the left side of the luggage compartment.
Route the remaining wire ends of the 9-wire wiring harness on the left side of the vehicle along the
vehicle's wiring harness to the front into the left footwell and then use the supplied 143 mm cable ties
to secure in place.
02.10.2015-054224 10 / 91