SOMFY Sunea 40 RTS Instrucciones página 10

EN
2.3.1.Pre-programming the control point
1] Connect the drive to the battery or to the external power supply, depending
on the type of installation (Wiring [} 6]).
2] Press the Up and Down buttons simultaneously on the control point:
ð The motorised product moves up and down.
g The control point is pre-programmed.
2.3.2.Checking the direction of rotation
Press the Up button on the control point:
a] If the motorised product rises, the direction of rotation is correct: move onto
section Setting the end limits.
b] If the motorised product lowers, the direction of rotation is incorrect: move onto
the next step.
b1] Press the my button on the control point until the motorised product moves up
and down: The direction of rotation has been modified.
b2] Press the Up button on the control point to check the direction of rotation.
2.3.3.Setting the end limits
2.3.3.1. Setting the end limits in semi-automatic mode (for a motorised product with
upper end stops)
The lower end limit must be set in manual mode, and the upper end limit is set
automatically:
1] Lower the motorised product to the desired position by pressing the Down
button.
2] Press the my and Up buttons simultaneously until the motorised product
rises.
ð The lower end limit is set.
3] Press the my button to stop the motorised product.
4] To confirm the end limits, press the my button until the motorised product
briefly moves up and down.
g The end limits are programmed.
2.3.3.2. Setting the end limits in manual mode
NOTICE
The end limits can be set in any order.
10
1]
ON
b1]
1]
3]
©
Copyright 2023 SOMFY ACTIVITES SA. All rights reserved.
Sunea 40 RTS DC
2]
]
a
]
b
b2]
2]
4]