Publicidad
Idiomas disponibles
Idiomas disponibles
1. Wall Outlet Location
2. Cooktop Installation
NOTE: Your gas cooktop includes 2 different bracket
and screw options. Select the bracket and screw
that works best with your installation.
1. Visually inspect the cooktop for damage.
2. Set the cooktop into the countertop cutout.
After inserting the cooktop into the countertop
opening, make sure the unit is sitting on the
metal flange around the top of the burner box.
Cooktop must not sit on the glass or the porce-
lain top. Avoid cutting an oversized hole in the
countertop.
3. If you are using Installation Bracket type 1, in-
sert the Angle Bracket as shown below (Fig. 6a):
Cooktop (Glass
or Porcelain)
Angle Bracket
Wood Screw
Figure 6a
10
Figure 5
Countertop
4. Once the cooktop is installed, insert the angle
bracket into the slot on each side of the unit as
shown (Fig. 6a) run wood screw to clamp the
unit down.
5. If you are using Installation Bracket type 2,
insert the thumb screw supplied (2) in the angle
bracket as shown below (Fig. 6b):
Angle
Bracket
Figure 6b
6. Once the cooktop is installed, clamp the unit
down, insert the angle bracket into the slot on
each side of the unit as shown (Fig. 6c). Run the
thumb screw up through the bracket, up against
the bottom of the counter. Tighten until the unit
draws down and is secure.
Cooktop (Glass
or Porcelain)
Angle Bracket
Figure 6c
¾" to 1"
(1.9 to 2.5 cm)
Thumb Screw
Seal (Porcelain Cooktop Only)
Countertop
Thumb Screw
AA-2328607-1
Publicidad
