Publicidad
Idiomas disponibles
Idiomas disponibles
4. Adjust the "LOW" Setting of Surface Burner
Valves (linear flow)
Test to verify if LOW setting should be adjusted:
a. Push in and turn control to LITE until burner
ignites.
b. Push in and quickly turn knob to lowest position.
c. If burner goes out, reset control to OFF.
d. Remove the surface burner control knob.
e. Insert a thin-bladed screwdriver into the hol-
low valve stem and engage the slotted screw
inside. Flame size can be increased or decreased
with the turn of screw. Turn counterclockwise to
increase flame size. Turn clockwise to decrease
flame size (Figure 12). Adjust flame until you
can quickly turn knob from LITE to lowest po-
sition without extinguishing the flame. Flame
should be as small as possible without extin-
guishing.
WARNING!
Do not remove center screw.
Figure 12
When All Hookups are Complete
Make sure all controls are left in the OFF position.
Make sure the flow of combustion and ventilation air
to the cooktop is unobstructed.
14
Before You Call for Service
Read the Before You Call for Service Checklist
and operating instructions in your User Manua. It
may save you time and expense. The list includes
common occurrences that are not the result
of defective workmanship or materials in this
appliance.
Refer to the warranty in your User Manual for our
service phone number and address. Please call or
write if you have inquiries about your product and/
or need to order parts.
AA-2328607-1
Publicidad
