Publicidad
BEFORE REQUESTING SERVICE
WARNING
Disconnect the electrical supply before servicing or cleaning the unit. Failure to do so
could result in electrical shock or personal injury from cleaner suddenly starting.
Review this chart to find do-it-yourself solutions for minor performance
problems. Any service needed, other than those described in these
Operating Instructions, should be performed by an authorized service
representative.
PROBLEM
Cleaner will
not run.
Poor job of dirt
pickup.
Light will
not work.
Electrical Shock or Personal Injury Hazard.
POSSIBLE CAUSE
1. Unplugged at wall outlet.
2. ON-OFF switch not turned on.
3. Tripped thermal protector.
4. Tripped circuit breaker/blown
fuse at household service panel.
1. Full or clogged dust bin.
2. Broken belt.
3. Carpet-bare floor setting incorrect.
4. Clogged hose or nozzle.
5. Hose not inserted fully.
6. Worn agitator.
7. Hole in hose.
8. Dust bin improperly installed.
9. Belt not installed on motor shaft.
1. Burned out light bulb.
POSSIBLE SOLUTION
1. Plug in firmly. Push ON-OFF
switch to ON.
2. Push ON-OFF switch to ON.
3. Unplug vacuum, wait thirty (30)
minutes, plug in and switch to ON.
4. Reset circuit breaker or replace
fuse.
1. Empty dust bin.
2. Replace belt.
3. Set in the correct position.
4. Clean hose or nozzle area.
5. Insert hose.
6. Replace agitator.
7. Replace hose.
8. Properly install dust bin.
9. Install belt on motor shaft.
1. Replace light bulb.
- 49 -
Publicidad
