Milwaukee 2970-20 Manual Del Operador página 28

2 M18™ Wireless Monitor
USB Cable Connection – The M18™ Wireless Monitor can also be powered by the
M18™ 500GB Control Hub battery via the supplied USB cable. This is extremely useful in
some emergency situations in case your battery runs low.
1. With the supplied USB cable, plug one end into the Control Hub and the other into the
Wireless Monitor.
2. Confirm the USB connection by checking the icons in the status bar on the right. When
connected by USB cable the Wi-Fi icon is now replaced by the cable-connect icon.
2021/09/26 01:47:57 AM
The above illustration shows the Wireless Monitor and Control Hub connected by Wi-Fi
with a weak monitor battery.
2021/09/26 01:47:57 AM
The above illustration shows the Wireless Monitor and Control Hub connected by USB
cable with the M18™ Battery removed from the Wireless Monitor. The Wi-Fi icon is
replaced by the cable-connect icon and the Wireless Monitor battery shows as empty.
2.2.11 M18™ Battery
Both the M18™ Wireless Monitor and M18™ Control Hub are powered by an M18™
Battery. The battery condition of both is always shown in the status bar on the Wireless
Monitor screen.
Recharge only with the charger specified for the battery. For specific
charging instructions, read the operator's manual supplied with your charger and
battery.
2021/09/26 01:47:57 AM
Camera Light
Camera Light
CAMERA LIGHT Camera Light
Battery status – the icon to the left of the Wireless Monitor icon
represents the battery status of the Control Hub while the icon to the
right represents the Wireless Monitor.
24
9.3FT
9.3FT
9.3FT