YATO YT-82194 Manual Original página 15

PRODUCT OVERVIEW
The plunge router is used to process wood and wood-based materials using shank cutters. The plunge router is equipped with
guides to facilitate straight and angle milling. The possibility of easily connecting the dust extraction system makes work safer.
The battery power supply allows working in places without easy mains access. The correct, reliable, and safe operation of the
appliance depends on its proper use, therefore:
Read the entire instructions manual before the fi rst use of the tool and keep it for future reference.
The supplier shall not be liable for any damage resulting from failure to comply with the safety instructions and recommendations
specifi ed in this instructions manual.
PRODUCT ACCESSORIES
The tool is delivered complete but requires preparation before beginning operation. The plunge router is supplied with diff erent
attachments allowing various milling methods, guides, dust extraction attachment, and a sleeve for mounting milling cutters with
a smaller handle diameter. The cutters, battery and battery charger are not supplied.
TECHNICAL DATA
Parameter
Catalogue No.
Mains voltage
Rated rpm
Milling unit stroke
Cutter shank diameter
Insulation class
Protection rating
Noise level
- sound pressure L ± K
pA pA
- sound power L ± K
wA wA
Vibration a ± K
h
Weight
Battery type
The declared noise emission value has been measured using the standard test method and can be used to compare one tool to
another. The declared noise emission value can be used in the preliminary exposure assessment.
The declared total vibration value has been measured using the standard test method and can be used to compare one tool to
another. The declared total vibration value can be used in the initial exposure assessment.
Caution! The vibration emission during tool operation may diff er from the declared value, depending on the manner the tool is
used.
Caution! Safety measures to protect the operator, which are based on an assessment of exposure under actual conditions of
use (including all parts of the work cycle, such as the time when the tool is switched off or idle and the activation time), must be
specifi ed.
GENERAL WARNINGS FOR THE SAFETY OF POWER TOOLS
Warning! Read all safety warnings, illustrations and specifi cations provided with this power tool. Failure to do so may
result in electric shock, fi re or serious injury.
Keep all warnings and instructions for future reference.
The term "power tool" used in warnings applies to all tools driven by power both wired and wireless.
Workplace safety
Keep the workplace well-lit and clean. Disorder and poor lighting can be causes of accidents.
Do not work with power tools in an environment with an increased risk of explosion, containing fl ammable liquids, gases
or vapors. Power tools generate sparks that can ignite dust or fumes.
Children and third persons should not be allowed to enter the workplace. Loss of concentration can result in loss of control.
O R I G I N A L
EN
Unit
[V DC]
[min ]
-1
[mm]
[mm]
[dB (A)]
[dB (A)]
[m/s 2 ]
[kg]
I N S T R U C T I O N S
Value
YT-82192
18
8,000 – 26000
55
6, 8
III
IPX0
78,0 ± 3.0
89,0 ± 3.0
2,47 ± 1.5
1.78
Li-Ion
15