Miele PDR 910 G Plano De Instalación página 42

en - Installation notes
Initial connection
Converting to an-
other gas type
42
einträchtigt werden!
Connection and conversion instructions
Shut-off equipment and connection hose for the gas connection
must be fitted by the customer on site.
A suitable connection hose can be purchased from Miele as an op-
tional accessory.
The initial connection must be carried out by a licensed specialist
company according to specific national regulations.
 The configuration ex works must allow the tumble dryer to be
operated with the relevant gas family, gas group and connection
pressure.
This tumble dryer is configured ex works for operation with natural
gas E (H), G 20.
The data plate provides information about the gas inlet pressure and
the corresponding jet pressure. Compare the specifications on the
data plate with those of the gas network operator.
The required gas valve settings are described in the accompanying
setting and conversion instructions.
 Danger if conversion work is not performed correctly.
Conversion work must be performed by authorised specialists only.
If the dryer is to be converted to a gas type other than the one spe-
cified on the data plate, refer to the accompanying setting and con-
version instructions.
47