Publicidad
Idiomas disponibles
Idiomas disponibles
To stop the product
1. Turn the speed control counterclockwise to the
lowest speed.
2. Release the drive levers.
3. Turn the start/stop and function selection switch to
the "0" position.
4. Stop the dust collector.
5. Disconnect the power supply.
To remove a soft floor surface
WARNING:
Kevlar. The blades are very sharp.
Note:
Blades with a smaller width cut the floors easier
than blades with a larger width. Blades with a larger
width are not always better or faster. A blade with a
smaller width usually cleans the floor better than a blade
with a larger width.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
1. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
2. Install a self scoring blade. Refer to
correct blade dimension and installation position on
page 11 and To replace the blade on page 19 .
14
Use protective gloves with
To select the
3. Make sure that the blade is sharp. Sharpen the
blade if it is necessary. Refer to
blade on page 19 .
4. Cut a linear ditch in the floor.
5. Remove the self scoring blade, refer to
the blade on page 19 .
6. Install a flat blade.
7. Start at the ditch and remove the floor.
1
To remove a hard floor surface
WARNING:
Kevlar. The blades are very sharp.
Note:
Blades with a smaller width cut the floors easier
than blades with a larger width. Blades with a larger
width are not always better or faster. A blade with a
smaller width usually cleans the floor better than a blade
with a larger width.
Note:
The blades are sharp for a longer time if the
work area is clean from unwanted material.
For instructions on how to remove tile floors and floors
made of wood, refer to
To remove tile floors and floors
made of wood on page 15 .
1. Use personal protective equipment. Refer to
Personal protective equipment on page 7 .
To sharpen the
To replace
2
Use protective gloves with
1804 - 003 - 28.08.2023
Publicidad
