Publicidad
Idiomas disponibles
Idiomas disponibles
Work area safety
WARNING:
instructions that follow before you use the
product.
•
Do not use the product in fog, rain, strong winds,
cold weather, risk of lightning or other bad weather
conditions.
•
Do not use the product in areas where fire or
explosions can occur.
•
Keep children, bystanders and animals away from
the work area and at a safe distance from the
product. A safe distance is 2 m.
•
Make sure that only approved persons are in the
work area.
•
Keep the work area clean and sufficiently
illuminated.
•
Remove objects such as screws, bolts, wires and
stones from the work area before you use the
product.
•
Make sure that there are no cables or hoses in the
operation direction of the product.
•
Make sure that there is sufficient airflow in the work
area.
Electrical safety
WARNING:
shocks from electrical products. Do not use
the product in bad weather conditions. Do
not touch lightning conductors and metal
objects. Always use the product as given in
this operator's manual to prevent injury.
WARNING:
with RCD (residual-current device). An RCD
decreases the risk of electrical shock.
WARNING:
unprotected parts in the power unit. Always
disconnect the power plug before you open
the door to the electrical box.
WARNING:
due to inadvertent resetting of the thermal
cut-out, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
WARNING:
supply for the product is supplied by
separate transformers that are used for
industrial purpose only.
8
Read the warning
There is always a risk of
Always use a power supply
High voltage. There are
In order to avoid a hazard
Make sure that the power
CAUTION:
the product or generator must be sufficient
and constant to make sure that the motor
operates without problems. Incorrect voltage
causes the power consumption and the
temperature of the motor to increase until
the safety circuit releases. The dimension
of the power cord must agree with national
and local regulations. The dimension of the
mains socket must agree with the amperage
for the electrical socket and extension cable
of the product.
If the power mains has higher system
resistance, short voltage drop can occur
when the product is started. This can
influence the operation of other products, for
example flicker on the lights.
•
Make sure that the power, fuse and mains voltage
are the same as the voltage shown on the rating
plate of the product.
•
Always stop the product before you disconnect the
power plug.
•
Do not use the product if the power cord or power
plug is damaged. Hand it in to an approved service
center for repair. A damaged power cord can cause
serious injury and death.
•
Use the power cord correctly. Do not use the power
cord to move, pull or disconnect the product. Pull the
power plug to disconnect the power cord. Do not pull
the power cord.
•
Do not operate the product in water depths where
the equipment of the product gets wet. The
equipment can become damaged and the product
can become live and cause injury.
•
Keep the product away from rain. Water that goes
into the product increases the risk of electrical shock.
•
Always disconnect the power cord before you
connect or disconnect the connection for the motor
cable and the electrical enclosure.
Grounded product instructions
WARNING:
result in electrical shock. Speak to an
approved electrician if you are not sure if
your mains outlet is correctly grounded.
Do not do modifications to the power plug
from its factory specification. If the power
plug or power cord is damaged or must be
replaced, speak to your Husqvarna service
agent. Obey local regulations and laws.
If you do not fully understand the
instructions about the grounded product,
speak to an approved electrician.
The power supply from
Incorrect connection can
1804 - 003 - 28.08.2023
Publicidad
