Publicidad
Idiomas disponibles
Idiomas disponibles
ttOW lO USE
USING THE CONTROLS
FAN
Pressing the FAN
button cycles the circulation
fan speed from low (F1) to medium (F2) to high
(F3).The selected fan speed
O
",_ will be shown in the LCD display.
FAN
J
The function can be used in
either COOL or FAN modes.
When changing
fan speeds, there is a brief
delay before the fan motor changes speed.
A / Y (TEMP/TIMER)
In COOL and DRY modes, the A/V(TEMP/TIMER)
buttons adjust the set temperature
up to 86°F or
down to 60°F, in one degree
_
A
O_
increments.
The temperature
can
be switched between degrees
T
Fahrenheit and degrees Celsius,
pressing theA button andV button
at the same time,or pressing °Cz°F
button on the
remote.
When the TIMER function is selected, use the
A,/V(TEMP/TIMER) buttons to adjust the delay
time from 1 to 24 hours, in one hour increments.
If you press and hold the A/V(TEMP/TIMER)
buttons, the set temperature
or time will change
automatically
after a few seconds.
NOTE: The displayed
temperature
is the SET
temperature,
not the room temperature.In
COOL,
DRYor ENERGYSAVER mode, the thermostat in the
air conditioner will run the compressor
until the
set temperature
is reached, then cycle the
compressor
on and off to maintain the set
tem pe ratu re.
TIMER
When theTIMER function is selected, you can set
the air conditioner
to either automatically
turn
iL
Oi
OFF °r turn ON after a delay °f
7_MER
up to 24 hours. The display will
show 0.Use the A/V(TEMP/TIMER)
buttons to adjust the delay
time from 1 to 24 hours, in one
hour increments.
To set an automatic
off delay, press the TIMER
button while the air conditioner
is running and
use the A/V(TEMP/TIMER)buttons
to adjust the
delay time. The air conditioner
will automatically
turn OFF after the set delay.
To set an automatic
on delay, press the TIMER
button while the air conditioner
is off and use
the A/V(TEMP/TIMER) buttons to adjust the
delay time.
The display will show the number of hours
remaining until the unit is set to come on. The
air conditioner will automatically
turn ON
after the set delay.
If you want to know how many hours you have
setted, press the TIMER button and then you
can see the time through the LCD display.
If you want to change the set timer,press
the
TIMER button and adjust the time when the
number is flickering.
To cancel the Timer function,one
method is
press the TIMER button and adjust the number
to"0" when the number is flickering,then
the
function will be canceled in a few seconds.
Another better method is Press the TIMER
button and Press this button again when the
number is still flickering.
NOTE: Do not unplug the air conditioner
when
using the timer function.
Publicidad
