Publicidad
Idiomas disponibles
Idiomas disponibles
POWER SWITCH (14)
Depress the switch to the "On" position. The red pilot light (LED) will illuminate indicating power is being
supplied to the unit.
„oo.
Ef q bo =
|
|
|
16
17
18
LINE CORD
(120V PRODUCTS
ONLY) (15)
HEADPHONE
OUT (16)
This stereo jack allows the signal to flow to both sides of any stereo headset. When headphones are connected
to the amplifier, the internal speaker is automatically turned off.
NOTE: The headphone system will not work with headsets equipped with a mono phone plug.
PREAMP
OUT/POWER
AMP IN (17)
NOTE: The preamp output level is approximately 1 volt RMS and is of relatively low impedance (600 ohms).
Any effects device used in this effects loop must be capable of receiving 1 volt input and providing 1 volt
output in order to properly drive the power amp. The Power Amp Input has an internal switch which discon-
nects the internal preamp.
REMOTE
SWITCH
(18)
For connection of a footswitch (optional) and is used to activate/defeat reverb.
ola
o
GE
Gei?
EH
PACK MOUNTED EFFECTS
PATCH DIAGRAM
Publicidad
